![]() ![]() Remains of old paints, coatings, grease, dust should be removed. After curing, the additional reinforcing layer subsequent operations are performed by conventional techniquesįiberglass cloth for painting with 2mm × 2mm mesh In the area of the basement to provide the necessary resistance against the attack on the surface of the insulation is made extra reinforcement armor-clad (vandal proof) fiberglass. The base layer in the area of the basement.To the unit base reinforcement layer is made extra special corner reinforcement angles nets with plastic PVC profiles. The corners of window and door openings are reinforced with additional strips of 200 - 300mm mesh size and are installed before applying the base reinforcing layer. The unit building corners of window and door openings.The primer surface should be done only after the curing and drying, leveling layers.īy reinforcing the basic unit of plaster embarking upon curing of the adhesive, the position fixing of insulation, and to achieve strong coupling it with the base, but not earlier than 24 hours after gluing. The substrate must be primed with a special compound deep impregnating agent. Inconsistencies in these structures must be completely remove the old coating. Spray coverage should be examined for compatibility with the adhesive composition. Bumps and drops more than 1cm should be removed, and the cracks are plastered. Old plaster should be checked by tapping the surface, in places hit by the detection of voids and restored. The wall surface having no decorative coatings should be thoroughly washed with water. Prepare the surface to the reinforcement:.Window and door openings are reinforced with additional strips of mesh width of 300mm and installed prior to the application of the first reinforcing layer.įiberglass mesh facade, exterior plaster reinforced fiberglass fabric 5mm×5mm The device of window and door openings.When completely dry painting and adhesive apply a final coat of plaster The application of the final layer of plaster.Place the corner pieces on plaster, grid pressed into plaster with a trowel or spatula ![]() The layer thickness reinforcement should be not less than 3mm Place the plaster mesh glass cloth on the inner surface in the form of vertical stripes with overlapping webs of at least 10cm, and press into the painting and adhesive mortar with a trowel or spreader.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |